RVGeek

RV & Truck Electronics best prices

Designed for hood and trunk applications, these stainless steel mounts go on the inside channel of your hood or trunk. There are no visible mounting holes required. All mounting hardware (also stainless steel) is hidden inside the hood or trunk channel. Mount comes complete with antenna mounting stud.

Product Features

  • Stainless steel construction
  • Mounts to the inside channel of your hood or trunk using included hardware/stud
  • Mounting hardware is hidden inside the hood or trunk channel
  • Compatible with most vehicles that have a hood and/or trunk, in channels up to 2″ deep
  • 2.1″ from mounting base to first bend, 2.9″ from mounting base to top of bracket

Get More Detailed Information About This Product…

“As an Amazon Affiliate I earn from qualifying purchases made from links in this post”

3 comments

  1. Scott says:

    Simple solution that is impressively strong 0

  2. J. Humphrey says:

    Nice quality… Great quality material (stainless steel). The channel mount didn’t work flawlessly with my Jeep XJ. I had to slightly bend the bracket to allow for connection of my coax. I realize that this bracket is not vehicle specific, so I wasn’t bothered by that. Since install, I did go off road with it attached and it held up like a champ. I would also suggest a spring mount for your antenna if this hood mount is going on an ORV. Otherwise, damage is likely to follow on the first low hanging…

  3. SnapShot says:

    Easy and Looks Great I purchased this hood/trunk mount to replace my tire carrier mount on my Wrangler JK. I had to fiddle with the location, as Wrangler hoods are domed and do not lay flat/flush with the front. I ended up installing this using a factory bolt at the base of the driver’s side windshield cowling (I will update a photo the clarify). I was able to run my coax under the hood and through the firewall on the passenger side. This paired with a quick-release antenna mount make it easy to remove (which is…

Comments are closed.